Measurement Mode; Restore Factory Setting - Omega CDTX-111 User Manual

Table 7 Set input range for the current output
Code
FIgS Conductivity start value
FIgE
FICS Temperature start value
FICE
4.3.4 SHSP—Measurement Mode
CDTX-111 has conductivity, resistivity, TDS and temperature four modes of
measurement and display functions, it can be selected in the SHSP program.
Select SHSP in the menu, press
SH 2. SH 0 is conductivity mode, SH 1 is resistivity mode, SH 2 is
temperature mode. Press
and return to the setting state. The indicator light also changes to indicate
that the display state changes. The corresponding parameters in the setting
also will automatically change.
*NOTE The sensor should be changed when switch the measurement mode.
Table 8
Code
SH 0 Display conductivity
SH 1 Display resistivity value
SH 2 Display Temperature
4.3.5 FACt—Restore Factory Setting
Select FACt in the menu, press
moment the instrument is being restored factory setting, about 10 seconds
it will automatically returns to FACt, restore factory setting is completed.
After this process, all value the user set before becomes the factory
Content
Conductivity end value
Temperature end value

Measurement Mode

Content
value
value
ENTER
into it and display SH 0 or SH 1 or
UP
to switch it, then Press
Indicator light
uS(mS)/cm
M
lights
C/F lights
ENTER
into it and display HHHH. At this
16
Range
0~1999uS/cm (k=1.0)
0~1999uS/cm (k=1.0)
0~100
0~100
Cell constant
K=0.01/0.1/1.0
cm lights
K=0.01/0.1/1.0
ENTER
to store
K=0.01