Table of Contents
Advertisement
Try Other Boot Device
Yes
Enabled other device to boot system. (Default Value)
No
Disabled other device to boot system.
Floppy Access Control
Read-Write
Set Floppy Access Control : Read-Write. (Default Value)
Read-Only
Set Floppy Access Control : Read Only.
Hard Disk Access Control
Set Hard Disk Access Control : Read-Write. (Default Value)
Read-Write
Read-Only
Set Hard Disk Access Control : Read Only.
S.M.A.R.T. for Hard Disks
Enable
Enable S.M.A.R.T. Hard for Disks.
Disable S.M.A.R.T. Hard for Disks. (Default Value)
Disable
Boot Up Num-Lock
Keypad is number keys. (Default Value).
On
Off
Keypad is arrow keys.
Floppy Drive Swap
Enabled
Floppy A & B will be swapped under DOS
Floppy A & B will be normal definition (Default Value).
Disabled
Floppy Drive Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360
type is 40 tracks while 720 , 1.2 and 1.44 are all 80 tracks.
Enabled
BIOS searches for floppy disk drive to determine if it is 40 or 80
tracks. Note that BIOS can not tell from 720, 1.2 or 1.44 drive type
as they are all 80 tracks.
Disabled
BIOS will not search for the type of floppy disk drive by track
number. Note that there will not be any warning message if the drive
installed is 360. (Default Value)
54
BIOS Setup
Advertisement
Chapters
Table of Contents
