Table of Contents
Advertisement
2mm
23
Position the fabric so that the
needle is 2mm (1/16 inch) in
front of the area to be darned,
and then lower the presser foot
lever.
When lowering the presser foot,
do not push in the front of the
presser foot, otherwise the
darning will not be sewn with
the correct size.
Pass the upper thread down
through the
hole in the presser foot.
Pull down the buttonhole lever.
The buttonhole lever is
positioned behind the bracket
on the buttonhole foot.
Gently hold the end of the
upper thread in your left hand,
and then start sewing.
Darning stitches are sewn from
the front of the presser foot to
the back, as shown.
If the sewing range is too big to
sew, then we suggest you can
sew several times (or cross sew)
to get better sewing result.
After sewing the d
raise the buttonhole lever all the
way up to its original position for
other sewing.
42
Note:
Attention:
arning stitches
,
Advertisement
Table of Contents
