Shut-Down - MULTIQUIP Whiteman WM120SH Series Operation Manual

Hydraulic plaster/mortar mixers
Hide thumbs Also See for Whiteman WM120SH Series:
Table of Contents

Advertisement

STOPPING THE MIXER (GASOLINE ENGINE)
1. Push the start/stop switch (Figure 29) inward to stop
the engine.
Figure 29. Start/Stop Switch (Stop)
2. Place the fuel valve (Figure 30) lever to the OFF
position.
Figure 30. Fuel Valve Lever (Off)
3. Clean mixer as referenced in the maintenance section
of this manual.
CAUTION —Start/Stop Switch
NEVER disable or disconnect the start/stop switch. It
is provided for operator safety. Serious Injury may
result if it is disabled, disconnected or improperly
maintained.
WM120PH/SH HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #7 (09/15/11) — PAGE 27
STOPPING THE MIXER (ELECTRIC MOTOR)
1. To stop the electric motor, press the red OFF/STOP
switch (Figure 31).
PRESS TO
STOP
Figure 31. Electric Motor On/OFF Switch (Stop)
2. Disconnect the electric motor's extension cord from
its power source.
3. Clean mixer as referenced in the maintance section of
this manual.

SHUT-DOWN

ON
OFF
STOP
START

Advertisement

Table of Contents
loading

Table of Contents