Gigabyte 7VT880-RZ User Manual page 26

Hard drive information should be labeled on the outside drive casing.
Enter the appropriate option based on this information.
Cylinder
Head
Precomp
Landing Zone
Sector
Drive A / Drive B
The category identifies the types of floppy disk (drive A and drive B) installed in the computer.
None
360K, 5.25"
1.2M, 5.25"
720K, 3.5"
1.44M, 3.5"
2.88M, 3.5"
Floppy 3 Mode Support (for Japan Area)
Disabled
Drive A
Drive B
Both
Halt on
The category determines whether the computer will stop if an error is detected during power up.
All Errors
No Errors
All, But Keyboard The system boot will not stop for a keyboard error; it will stop for all other
All, But Diskette
All, But Disk/Key
Memory
The category is display-only which is determined by POST (Power On Self Test) of the BIOS.
Base Memory
The POST of the BIOS will determine the amount of base (or conventional) memory installed
in the system.
The value of the base memory is typically 512K for systems with 512K memory installed on
the motherboard, or 640K for systems with 640K or more memory installed on the motherboard.
Extended Memory
The BIOS determines how much extended memory is present during the POST.
This is the amount of memory located above 1 MB in the CPU's memory address map.
Total Memory
This item displays the memory size that used.
7VT880-RZ Series Motherboard
Number of cylinders
Number of heads
Write precomp
Landing zone
Number of sectors
No floppy disk is installed
5.25 inch PC-type standard drive; 360K byte capacity.
5.25 inch AT-type high-density drive; 1.2M byte capacity
(3.5 inch when 3 Mode is Enabled).
3.5 inch double-sided drive; 720K byte capacity
3.5 inch double-sided drive; 1.44M byte capacity.
3.5 inch double-sided drive; 2.88M byte capacity.
Normal Floppy Drive. (Default value)
Enable Drive A 3 Mode support.
Enable Drive B 3 Mode support.
Enable both Drive A and B 3 Mode support.
Whenever the BIOS detects a non-fatal error the system will stop.
The system boot will not stop for any error that may be detected and you
will be prompted.
errors. (Default value)
The system boot will not stop for a disk error; it will stop for all other errors.
The system boot will not stop for a keyboard or disk error; it will stop for all
other errors.
- 26 -