Advertisement
Projection on the screen (Continued)
4
Adjust the picture size by turning the
zooming ring.
Turn to the right to enlarge the picture.
Turn to the left to reduce the picture.
5
Focus on the picture by turning the
focusing ring.
A still picture is recommended for focusing.
Notes
• When changing the projecting angle, adjust the foot adjuster.
• When the screen image is distorted in keystone, press the KEYSTONE button on the
remote controller.
29
• "
" is displayed on the screen if the projector does not receive any signal from the
connected equipment. Put the equipment in playback mode.
• Due to the lamp characteristic, flickers may occasionally occur in a picture. This is not
malfunction of the unit.
• While operating the projector, "
operation cannot be completed.
• "
" is displayed on the screen if:
- The projector is too hot. Turn the projector off, and leave it for a while, and then turn it
on again.
- The ambient temperature is too high, use the projector under moderately cold
temperature.
• "
" is displayed on the screen if the air filter is dusty, the ventilation is impaired. This
may cause the temperature inside the projector to rise. Clean the air filter.
19
" may be displayed on the screen. This means that the
CONTENTS
27
55
Advertisement
