Brother 888-E40 Operation Manual page 53

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
c Use a chalk to mark on the fabric about 5 mm
(3/16 inch) from the edge of the fabric, and
then baste it.
3
1
1
1
<Seen from the side>
d Fold back the fabric inside along the basting.
3
4
1
1
1
<Seen from the side>
e
Unfold the edge of fabric, and position the
fabric with the wrong side facing up.
4
1
6
1
1
<Seen from the side>
f Attach blind hem foot "R".
g
Select a stitch.
h Remove the flat bed attachment and make
free-arm sewing possible.
• For details on free-arm sewing, refer to
"Stitching cylindrical pieces" (page 46).
6
a Wrong side of fabric
5
b Right side of fabric
c Edge of fabric
d Desired edge of hem
4
e 5 mm (3/16 inch)
2
f Basting
2
<Thick fabric>
2
<Normal fabric>
a Wrong side of fabric
5
b Right side of fabric
c Edge of fabric
d Desired edge of hem
6
e 5 mm (3/16 inch)
f Basting
2
g Basting point
7
<Thick fabric>
<Normal fabric>
a Wrong side of fabric
b Right side of fabric
c Edge of fabric
3
d Desired edge of hem
1
e Basting point
f Basting
1
5 <Thick fabric>
2
<Normal fabric>
i Slide the part that you wish to sew onto the
arm, make sure that the fabric feeds correctly,
and then start sewing.
a Arm
j Position the fabric with the edge of the folded
hem against the guide of the presser foot, and
then lower the presser foot lever.
a Wrong side of fabric
b Fold of hem
c Guide
k Adjust the stitch width until the needle
slightly catches the fold of the hem.
a Needle drop point
When you change the needle drop point, raise
the needle, and then change the stitch width.
Stitch width
a Thick fabric
b Normal fabric
R
R
51
3