Brother 888-E40 Operation Manual page 106

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
c Remove the upper thread and bobbin.
• Refer to "Fabric is caught in the machine and
cannot be removed" (page 99).
d Remove the bobbin case.
• Refer to "Fabric is caught in the machine and
cannot be removed" (page 99).
e If threads remain in the bobbin case, remove
it.
• Refer to "Fabric is caught in the machine and
cannot be removed" (page 99).
f Insert the bobbin case so that the
the bobbin case aligns with the
machine.
• Refer to "Cleaning the race" (page 91).
g Attach the needle plate cover.
• Refer to "Cleaning the race" (page 91).
h Set the bobbin in the bobbin case.
• Refer to "Cleaning the race" (page 91).
i If the needle is bent, replace it with a new
one.
• Refer to "Replacing the needle" (page 32).
j Turn on the machine, and then press the
needle position button to raise the needle.
• Refer to "Upper threading" (page 25).
k Thread the machine correctly.
• For details on threading the machine, refer to
"Upper threading" (page 25).
Symptom 3 :
The needle breaks, or the needle
bends and thus hits the needle
plate.
■ Cause
You have not used the right combination of
fabric, thread and needle.
■ Remedy
Choose a thread and needle that are appropriate
for the type of fabric.
• Refer to "Needle types and their uses"
(page 31).
104
Symptom 4 :
The fabric is not fed.
■ Cause
The thread has become clogged as the stitch is too
fine.
■ Remedy
Lengthen the stitch length.
• Refer to "Adjusting the stitch length and width"
(page 40).
mark on
mark on the