Brother 888-E40 Operation Manual page 26

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e While lightly holding down the bobbin with
your right hand as shown, guide the thread
a
through the slit (
• At this time, check that the bobbin easily
rotates counterclockwise.
Then, pull the thread toward you to cut it with
c
the cutter ( ).
a Slit
b Cutter (Cut the thread with the cutter.)
Note
● If the thread is not correctly inserted
through the tension-adjusting spring of the
bobbin case, it may cause incorrect thread
tension (page 43).
1
a Tension-adjusting spring
24
b
and ).
f Replace the bobbin cover. Put the left tab in
place (see arrow a), and then press lightly on
the right side (see arrow b) until the cover
clicks into place.
Memo
● You can begin sewing immediately without
drawing up the bobbin thread. If you want
to draw up the bobbin thread before you
start to sew, follow to the procedure in
"Drawing up the lower thread" (page 30).