Switching Af/Mf - Panasonic LUMIX S PRO Operating Instructions Manual

Note
When carrying, the lens hood can be attached in the
0
reverse direction.
1 Remove the lens hood.
2 Align mark C ( ) on the lens hood with the mark
on the tip of the lens.
3 Attach the lens hood by rotating it in the direction of
the arrow until it clicks.

It is recommended to remove the lens hood during flash
0
photography as the lens hood can block the light from the flash.
To prevent dropping of the lens, you should never carry
0
the lens by just holding the lens hood.
∫ Notes on filter use
It is possible to attach the lens cap or the lens hood
0
with the filter already attached.
If you use two or more filters at the same time, part of a
0
recorded image may darken.
It is not possible to attach any items other than filters
0
such as a conversion lens or adaptor to the front of the
lens and use it in combination with this lens.
Lens damage may result if such items are attached.

Switching AF/MF

Switch AF/MF by sliding the
focus ring A forwards or
backwards (focus clutch
mechanism).
When the digital camera is
0
set to MF, the operation will
be MF irrespective of the
position of the focus ring.
Check the length indication
0
B when using MF. Use it as a
guide for focusing.
You can set the amount that
0
the focus moves with the
focus ring using menu
settings in compatible digital
cameras. Switch the lens to
AF and set the digital camera to MF. Refer to the
operating instructions for the digital camera for details.
AF MF


1.5 2 3 5 13 ft
0.44 0.6 0.9 1.5 4 m
23
DVQX1747