Switching Af/Mf - Panasonic Lumix H-X1025 Operating Instructions Manual

Note
When carrying, the lens hood can be attached in the
0
reverse direction.
1 Remove the lens hood.
2 Align mark B (
on the tip of the lens.
3 Attach the lens hood by rotating it in the direction of
the arrow until it clicks.

It is recommended to remove the lens hood during
0
flash photography as the lens hood can block the light
from the flash.
To prevent dropping of the lens, you should never carry
0
the lens by just holding the lens hood.
∫ Notes on filter use
It is possible to attach the lens cap or the lens hood
0
with the filter already attached.
There may be some vignetting in recorded images if
0
multiple filters are attached simultaneously.
It is not possible to attach any items other than filters
0
such as a conversion lens or adaptor to the front of the
lens and use it in combination with this lens.
Lens damage may result if such items are attached.
22
DVQX1834
(ENG)
) on the lens hood with the mark

Switching AF/MF

Switch AF/MF by sliding the
focus ring A forwards or
backwards (focus clutch
mechanism).
When the digital camera is
0
set to MF, the operation will
be MF irrespective of the
position of the focus ring.
Check the length indication
0
B when using MF. Use it as a
guide for focusing.
AF MF


1 1.2 1.5 2.5 5 feet
0.28 0.33 0.4 0.5 0.7 1.5 m