Hard Drive Replacement - Buffalo LS220D0802-EU User Manual

4
Enable quotas, choose the maximum space the group is allowed, and click OK.
5
Click OK.
6
In Advanced Settings, click
7
Select the user who will inherit the group quota settings.
8
Change the user's primary group to the group with the quota, then click OK.
9
Click OK.
10
Click the

Hard Drive Replacement

If a drive fails, NAS Navigator2 and Settings will show an error message.
Notes:
• Do not replace a running drive while the LinkStation is turned on. Power down the LinkStation before
changing the drive. While the LinkStation is running, never unplug or remove drives without dismounting
them first.
• For the replacement drive, use a Buffalo OP-HDBST series drive of the same size or larger. If a larger drive is
used, the extra space will not be usable in a mirrored RAID array.
• If sending a defective drive to Buffalo for replacement, please keep the cartridge as Buffalo will only replace
the hard drive and not the cartridge.
• To avoid damaging the LinkStation with static electricity, ground yourself by touching something made of
metal before handling any sensitive electronic parts.
• After a drive is replaced, it will take about 30 minutes before normal file reading and writing are restored.
Settings may not be accessible during this period.
• Do not change the order of the hard drives in the LinkStation. For example, pulling out drive 1 and replacing
it with drive 2 may cause data to be corrupted or lost.
• If a new drive is not recognized after installing it, click Rediscover Disk in Settings.
to the right of "Users".
icon and select Restart to apply the quota settings.
56