Philips CEM2101/10 User Manual page 9

3
Connect the antenna and amplifier as
illustrated, if applicable.
Connector
1 ANTENNA
2 REAR LINE OUT R
(Socket)
3 REAR LINE OUT L
(Socket)
4 OE REMOTE (Purple)
Tip
•
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the unit.
Mount into the dashboard
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
8 EN
Connect to
Antenna
Rear right
speaker
Rear left speaker
OE Remote
2
Ensure that car dashboard opening is
within these measurements:
3
Remove the mounting sleeve with the
supplied disassembly tools.
4
Install the sleeve into the dashboard and
bend the tabs outward to fix the sleeve.
Note
•
If the unit is not fixed by sleeve but by the supplied
screws, skip this step.