System Admin - D-Link DIR-2660 User Manual

Section 4 - Configuration
This page will allow you to change the administrator (Admin) password and
enable remote management. In the Management menu on the bar on the top
of the page, click System Admin. To load, save, reset settings, or reboot the
router, click System and refer to Schedule on page 77.
Admin Password
Password: Enter a new password for the administrator account. You will need to
enter this password whenever you configure the router using a web
browser.
Enable Graphical
Enables a challenge-response test to require users to type letters or
Authentication numbers from a distorted image displayed on the screen to prevent
(CAPTCHA):
online hackers and unauthorized users from gaining access to your
router's network settings.
Advanced Settings - Administration
Enable HTTPS Check to enable HTTPS to connect to the router securely. Instead of using
Server: http://dlinkrouter.local./, you must use https://dlinkrouter.local./ in
order to connect to the router.
Enable Remote Remote management allows the DIR-2660 to be configured from the
Management: Internet by a web browser. A password is still required to access the web
management interface.
Remote Admin The port number used to access the DIR-2660 is used in the URL. Example:
Port: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address of the DIR-2660
and 8080 is the port used for the web management interface.
Note: If you enabled Use HTTPS and wish to access the router remotely and
securely, you must enter https:// at the beginning of the address.
Click Save when you are done.
D-Link DIR-2660 User Manual

System Admin

80