Main Menu - Panasonic PT-MZ570 Operating Instructions Manual

4) Press as to select a sub‑menu, and press qw or the <ENTER> button to change or adjust settings.
f Some items will switch in order as follows each time you press qw.
f For some items, press qw to display an individual adjustment screen with a bar scale as shown below.
Note
f Pressing the <MENU> button while the menu screen is displayed returns to the previous menu.
Same operation is available by pressing the <RETURN> button.
f Some items cannot be adjusted or some functions cannot be used depending on the signal that is input to the projector.
The item in the menu screen is displayed in black text when it cannot be adjusted or selected.
If the item in the menu screen is displayed in black characters and the item cannot be adjusted or set, the factor causing it is displayed by
pressing the <ENTER> button while the corresponding menu is selected.
f Some items can be adjusted even if signals are not input.
f Individual adjustment screen is cleared automatically if no operation is performed for approximately five seconds.
f For menu items, refer to "Main menu" (x page 81) and "Sub-menu" (x page 82).
f The cursor color depends on the setting in the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD DESIGN]. The selected item
is displayed with the yellow cursor by the factory default.
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu vertically, change the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD
ROTATION].
Resetting adjustment values to the factory default
If the <DEFAULT> button on the remote control is pressed, the values adjusted in the menu items are restored to
the factory default settings.
button
1) Press the <DEFAULT> button on the remote control.
Note
f You cannot reset all the settings to the factory default at a time.
f To reset all the settings adjusted in the sub-menu item to the factory default one at a time, execute the [PROJECTOR SETUP] menu →
[INITIALIZE].
f Some items cannot be reset to the factory default settings even when the <DEFAULT> button on the remote control is pressed. Adjust those
items individually.
f The triangular mark under the bar scale in the individual adjustment screen indicates the factory default setting. The position of the triangular
mark varies according to the selected input signals.

Main menu

The following items are in the main menu.
When a main menu item is selected, the screen changes to a sub-menu selection screen.
[PICTURE]
[POSITION]
[ADVANCED MENU]
Chapter 4 Settings — Menu navigation
A
CONTRAST
ADJUST
CONTRAST
ADJUST
Current adjustment value
Factory default setting
Main menu item
B C
0
0
Page
85
90
96
ENGLISH - 81