Page 1
DX4C DX4C 4 - Cha n n el 2.4G Hz DS M R™ S yste m 4 - Cha n n el 2.4G Hz DS M R™ S yste m Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di istruzioni...
Page 2
WARNING AGAINST COUNTERFEIT PRODUCTS Always purchase from a Horizon Hobby, LLC authorized dealer to ensure authentic high-quality Spektrum product. Horizon Hobby, LLC disclaims all support and warranty with regards, but not limited to, compatibility and performance of counterfeit products or products claiming compatibility with DSM or Spektrum.
SySTEM FEATURES • One-touch easy-to-use programming The DX4C radio system is supplied with the following: • Programmable Up or Down timers • DX4C Transmitter • 56 (high) x 64 (wide) high-resolution dot-matrix screen • SRS4210 Receiver (SPMSRS4210) • 20-model memory • Bind Plug (SPM6802) • Travel adjust • Grip Set (SPM9006) • Exponential • Steering mix • Programmable mix • AVC – Active Vehicle Control Spektrum DX4C • tranSmitter inStruCtion manual...
Main Screen will show on the LCD screen INSTAllING BATTERIES CAUTION: NEVER remove the transmitter batteries while the model is powered on. Loss of model control, damage or injury may occur. Spektrum DX4C • tranSmitter inStruCtion manual...
RaceWare firmware updates on your DX4C transmitter: 3. Install the SD card in the card reader slot on the DX4C transmitter. 4. Power on the transmitter. A Spektrum logo and an installation bar will appear. Installation is complete when the Main screen appears.
™ ® • The Spektrum SRS4210 DSMR Surface receiver is compatible with all Spektrum DSMR transmitters and is also backwards compatible with DSM2 transmitters. The SRS4210 receiver is NOT compatible with DSM transmitters. • The SR410 DSMR receiver is ONLY compatible with DSMR transmitters.
Failsafe will NOT activate in recommended minimums or power to the receiver is lost. the event that receiver battery power decreases below the recommended minimums or power to the receiver is lost. Spektrum DX4C • tranSmitter inStruCtion manual...
(generally full brake and neutral steering), initiate the 6. Pull the transmitter trigger to Full Throttle. bind process with your Spektrum transmitter. This stores the 7. Push the transmitter trigger to Full Brake, then return the failsafe position. Continue to hold the failsafe position until trigger to center.
B Active Screen name shows at the top of the screen. C Choosing this arrow will return to the previous screen. D A small bar shows relative position of highlighted screen name in the List. Spektrum DX4C • tranSmitter inStruCtion manual...
Travel values that Aux 1 H (high) L (low) are too high will cause binding, which may result in damage Aux 2 H (high) L (low) to the vehicle. Spektrum DX4C • tranSmitter inStruCtion manual...
9. Turn the transmitter steering wheel to Full Left, then return D Mode the steering wheel to center. The orange LED flashes once. E Speed 10. Remove the bind plug once the calibration and binding process is complete. 11. Power off the transmitter. Spektrum DX4C • tranSmitter inStruCtion manual...
Screen when an model memory is active. Tip: You can only change a model name when the model memory is active. A Active model memory B Model Name (10 character spaces available) C Marker showing selected character Spektrum DX4C • tranSmitter inStruCtion manual...
Assigns Steering rate to a switch so a driver can make on-the-fly steering travel adjustments. Steering rate limits the amount of travel of the steering servo. Lin (Linear) 3P (3 position) 2P (2 position) Spektrum DX4C • tranSmitter inStruCtion manual...
F Choosing No returns to the List Screen G Choosing Yes saves active model settings to the selected model memory IMPORTANT: Model information saved in a memory is erased and overwritten by active model settings using this Copy function. Spektrum DX4C • tranSmitter inStruCtion manual...
For example, if you increase Priority to 80%, you reduce the AVC steering control by 80% at full left or full right steering. Increasing the Steering Priority enables you to make tighter turns. Spektrum DX4C • tranSmitter inStruCtion manual...
G The assigned switch (A, B, C, D or E) lets a driver enable front/rear steering mix rate 1 or 2. h Position 1 for the assigned switch. I Position 2 for the assigned switch. Spektrum DX4C • tranSmitter inStruCtion manual...
The steering channel was reversed after the wrong way when Rebind and calibrate calibration the car slides/rotates The throttle does not The throttle channel was reversed after reduce when the car Rebind and calibrate calibration slides/rotates Spektrum DX4C • tranSmitter inStruCtion manual...
Proof-of-purchase date. Provided warranty conditions have been met, your product will be serviced or replaced free of charge. Service or replacement decisions are at the sole discretion of Horizon. Spektrum DX4C • tranSmitter inStruCtion manual...
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may When operating your Spektrum transmitter, please be sure to not cause harmful interference, and (2) this device must accept...
EN 301 489-17 v2.1.1: 2009 EN 60950-1:2006+A11:2009+A1:2010+A12: 2011 EN 62311: 2008 Signed for and on behalf of: Horizon Hobby, LLC Champaign, IL USA November 20, 2014 Mike Dunne Executive Vice President Product Divisions Horizon Hobby, LLC Spektrum DX4C • tranSmitter inStruCtion manual...
Page 21
DSM2, DSMR, RaceWare, ModelMatch, Active Vehicle Control, AVC and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. The SD Logo is a trademark of SD-3C, LLC...
Need help?
Do you have a question about the SPM4200W and is the answer not in the manual?
Questions and answers