Table of Contents
Advertisement
EN
FUNCTION LIST
SYSTEM SETTINGS (CONTINUED)
Alarm:
Set the low voltage for each battery type. The recommended low voltage threshold is set by default for each
battery type.
CAUTION: Never select NiMH when a LiPo/Li-Ion battery is installed in the transmitter. Doing so may over-
discharge the LiPo battery and damage the battery, transmitter or both.
CAUTION: Never adjust the low voltage limit for the LiPo/Li-Ion battery pack below 6.4V. Doing so could
over-discharge the battery pack and damage both battery pack and transmitter.
Language:
Change the transmitters language.
Inactive Alarm:
An alarm activates if the transmitter sees a period of inactivity for a certain amount of time. The alarm is
helpful in reminding you to power off the transmitter and avoiding a situation where the transmitter battery
completely discharges.
• Inh (No alarm sounds)
• 5 min
TRIMS
Assign Trims to any trimmer or switch on the transmitter.
1.
Select the Trim position from the list.
2.
Push the scroll wheel once to select the position.
3.
Scroll to select the Trim desired in that position.
4.
Click the scroll wheel to save the selection.
SOUND SETTINGS
Turn system sounds ON/OFF.
1.
Select the sound from the list.
2.
Push the scroll wheel once to Activate/Inhibit.
3.
Click the scroll wheel to save the selection.
ABOUT
Displays the transmitter's Serial Number.
CALIBRATE
Use this menu to calibrate controls. After making any physical transmitter changes it is recommended to
calibrate the transmitter.
1.
Move the Steering Wheel, Throttle/Brake and the knob from stop to stop.
2.
Centert the knob.
3.
Save when finished or cancel to go back.
18
• 10 min (Default)
• 30 min
SPEKTRUM DX5R • TRANSMITTER INSTRUCTION MANUAL
• 60 min
Advertisement
Table of Contents
