Installing Hook; Operation - Makita DTWA100 Instruction Manual

For impact socket with O-ring and pin
1
2
► 1 . Impact socket 2. O-ring 3. Pin
Move the O-ring out of the groove in the impact socket
and remove the pin from the impact socket. Fit the
impact socket onto the square drive so that the hole in
the impact socket is aligned with the hole in the square
drive.
Insert the pin through the hole in the impact socket and
square drive. Then return the O-ring to the original posi-
tion in the impact socket groove to retain the pin.
To remove the impact socket, follow the installation
procedures in reverse.
Tool with the detent pin
1
2
3
► 1 . Impact socket 2. Hole 3. Square drive 4. Detent
pin
Align the hole in the side of the impact socket with the
detent pin on the square drive and push the impact
socket onto the square drive until it locks into place. Tap
it lightly if required.
To remove the impact socket, simply pull it off. If it is
hard to remove, depress the detent pin while pulling the
impact socket.

Installing hook

Optional accessory
The hook is useful to hang the tool. Install the hook to
3
the holes on the tool body.
► 1 . Hook 2. Hole

OPERATION

all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of the
tool, causing injury to you or someone around you.
impact socket over the bolt or nut. Turn the tool on
and fasten for the proper fastening time.
4
until the battery cartridge has discharged, allow the
tool to rest for 15 minutes before proceeding with a
fresh battery cartridge.
not speed up the drilling. In fact, this excessive pressure
will only serve to damage the tip of your drill bit, decrease
the tool performance and shorten the service life of the tool.
vise or similar hold-down device.
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc.
13 ENGLISH
1
2
CAUTION:
Always insert the battery cartridge
CAUTION:
Hold the tool firmly and place the
CAUTION:
If the tool is operated continuously
CAUTION:
Pressing excessively on the tool will
CAUTION:
Always secure workpieces in a
2