Bevel Cutting; Adjusting Depth Of Cut - Makita DHS660RTJ Instruction Manual

► 1 . Mode indicator
The mode indicator lights up in green when the tool is
running in "high torque mode".
If the tool is operated with excessive load, the mode
indicator will blink in green. The mode indicator stops
blinking and then lights up or turns off if you reduce the
load on the tool.
Mode indicator status
On Off

Adjusting depth of cut

CAUTION:
After adjusting the depth of cut,
always tighten the lever securely.
Loosen the lever and move the base up or down to align the
pointer with your desired depth on the depth guide. At the
desired depth of cut, secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.
► 1 . Pointer 2. Lever
1
Operation
mode
Blinking
High speed
mode
High torque
mode
Overload
alert
1
2
10 ENGLISH
You can read the cut depth with the scale on the lower guard.
1
► 1 . Lower guard 2. Bottom of the tool base 3. Scale

Bevel cutting

CAUTION:
After adjusting the bevel angle,
always tighten the lever and clamping screw
securely.
Loosen the lever and clamping screw. Set for the
desired angle by tilting accordingly, then tighten the
lever and clamping screw securely.
► 1 . Lever 2. Clamping screw
Use the stopper when you do precise 45° angle cutting.
Fully turn the stopper as illustrated depending on 0° -
45° bevel cut or 0° - 50° bevel cut.
0° - 45°
0° - 50°
► 1 . Stopper
2
3
1
2
1