Product Data Sheets; Warranty - Whirlpool Inglis IS22AGXTQ00 Use & Care Manual

This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in ANSI/NSF 42/53.
Substance Reduction NSF Reduction
Aesthetic Effects Requirements
≥50%
Chlorine Taste/Odor
≥85%
*
Particulate Class II
Contaminant NSF Reduction
Reduction Requirements
Lead: @ pH 6.5 0.01 mg/L
Lead: @ pH 8.5 0.01 mg/L
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 63°F (17.2°C).
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-NL240: Change cartridge at least every 6 months.
Use replacement cartridge NL240, part #4396508.
2006 suggested retail price of $32.99. Prices are subject to
change without notice.
Model WF-L400: The filter monitor system measures the amount
of water that passes through the filter and alerts you to replace
the filter. When 90% of the filter's rated life is used, the filter
indicator light changes from green to yellow. When 100% of the
filter's rated life is used, the filter indicator light changes from
yellow to red, and it is recommended that you replace the filter.
Use replacement cartridge L400, part #4396508. 2006 suggested
retail price of $32.99. Prices are subject to change without notice.
* Class II particle size: >1 to <5
** Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
***
® NSF is a registered trademark of NSF International.
12

PRODUCT DATA SHEETS

Base Grille Water Filtration System
Model WF-NL240/NL240 Capacity 240 Gallons (908 Liters)
Model WF-L400/L400 Capacity 400 Gallons (1514 Liters
Tested and certified by NSF International against ANSI/NSF
Standard 42 for the reduction of Chlorine Taste and Odor,
Particulate Class II*; and against ANSI/NSF Standard 53 for the
reduction of Lead.
Average Influent Challenge
Influent Concentration
1.9 mg/L 2.0 mg/L ± 10%
833,333/mL At least 10,000
particles/mL
Average Influent Challenge
Influent Concentration
0.15 mg/L*** 0.15 mg/L ± 10%
0.15 mg/L*** 0.15 mg/L ± 10%
Maximum Average
Effluent Effluent
0.05 mg/L 0.05 mg/L
100,000/mL** 40,667/mL
Maximum Average
Effluent Effluent
0.001 mg/L 0.001 mg/L
0.003 mg/L 0.001 mg/L
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the
system.
Refer to the front cover or "Assistance or Service" section for the
Manufacturer's name, address and telephone number.
Refer to the "Warranty" section for the Manufacturer's limited

warranty.

Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
)
Minimum % Average %
Reduction Reduction
97.4% 97.4%
88.0% 95.1%
Minimum % Average %
Reduction Reduction
99.3% 99.3%
97.9% 99.0%
City or Well
30 - 120 psi (207 - 827 kPa)
° - 100°F (0.6° - 37.8°C)
33
0.5 gpm (1.9 Lpm) @ 60 psi.