Reinstall Hinges On Door; Reverse Strike Plate - Whirlpool MGDC465HW Installation Instructions Manual

REINSTALL HINGES ON DOOR

1. Using the screws you set aside, reinstall hinge B (removed
from the lower-left corner of the door) in the upper-right
corner. Tighten all screws.
2. Using the screws you set aside, reinstall hinge A (removed
from the upper-left corner of the door) in the lower-right
corner. Tighten all screws.
A
B
3. Replace the door hinge covers.
24

REVERSE STRIKE PLATE

1. Using a T20 screwdriver, remove the two screws securing
®
the strike plate and move the strike plate from the left side
of the dryer cabinet to the right side, securing it with the
removed screws.
B
2. Hang the door on the unit by placing set pin in dryer cabinet
A
hole and sliding door down. Using a Phillips screwdriver, install
screws 1 and 3 and then screws 2 and 4. Tighten all hinge
screws.
1
2
3
4
3. Install the plastic cover from the accessory kit into the space
where the lower hinge was removed. Place the plastic hinge
covers over the exposed hinges.
Set Pin