Whirlpool MGDC465HW Installation Instructions Manual page 23

7. Using a #2 Phillips screwdriver, remove the magnet latch
and install it on the other side of the door.
Remove housing
Holding it tightly,
lift magnet off of shim
IMPORTANT: Because the magnetic force is strong, it is
important to maintain a firm grip and to slide the magnet with a
steady, gradual movement. Doing so can keep the magnet from
reattaching to the metal surface and breaking, or from possibly
pinching your fingers.
A
Holding it tightly,
slide magnet over
Remove shim
After removing the magnet latch, move it to the opposite side
of the door by reversing the steps above:
Make sure arrow on front
of shim points up
Screw on shim
Holding magnet tightly,
slide into place
Rear of shim is embossed
to ensure correct seating in
opening
Holding magnet tightly, place
edge of magnet on shim and
lower magnet so edge rests
flatly on shim
Screw on housing
23