Table of Contents
Advertisement
Reverse door swing square-shaped door
1.
Remove door from dryer
Using a T25
screwdriver, remove the 4 screws securing the
®
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Retain or set aside the 4 screws.
2.
Move the door strike
Using a T25
screwdriver, remove the 2 screws securing
®
the door strike to the door frame of the dryer. Remove the 4
screws above and below the door strike and set aside for later
use. Rotate the strike 180° and attach to the opposite side of
dryer door frame as shown.
3.
Remove inner door from outer door
Release tab
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and
set aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
4.
Remove hinge and latch
from inner door
Hinge
Using a T25
screwdriver, remove the 3 screws securing
®
the latch plate and the 5 screws holding the hinge assembly
in place.
Release tab
Latch
25
Advertisement
Table of Contents
