Yamaha Aventage MusicCast RX-A1070BL Owner's Manual page 132

■ Manual network settings
1
Set "DHCP" to "Off".
2
Use the cursor keys (q/w) to select a parameter type and press ENTER.
IP Address Specifies an IP address.
Subnet Mask Specifies a subnet mask.
Default Gateway Specifies the IP address of the default gateway.
DNS Server (P) Specifies the IP address of the primary DNS server.
DNS Server (S) Specifies the IP address of the secondary DNS server.
3
Use the cursor keys (e/r) to move the edit position and the cursor keys (q/w) to select a
value.
4
To confirm the setting, press ENTER.
5
To configure another network parameter, repeat steps 2 to 4.
6
To save the changes, use the cursor keys to select "OK" and press ENTER.
7
To exit from the menu, press ON SCREEN.
■ Network Standby
Selects whether the unit can be turned on from other network devices (network standby).
Settings
Off Disables the network standby function.
Enables the network standby function.
On
(The unit consumes more power than when "Off" is selected.)
Enables the network standby function.
Auto
(If "Network Connection" is set to "Wired", the unit is set to the power saving
mode when the network cable is disconnected.)
With an advanced energy saving design, this product achieves a low power consumption of not
more than two watts when in Network Standby mode.
■ MAC Address Filter
Sets the MAC address filter to limit access to the unit from other network devices.
Filter
Enables/disables the MAC address filter.
Settings
Off Disables the MAC address filter.
Enables the MAC address filter. In "MAC Address 1-10", specify the MAC addresses
On
of the network devices that will be permitted access to the unit.
X
AirPlay (p.92) and DMC (p.112) operations are not subject to the MAC address filter.
MAC Address 1-10
Specifies the MAC addresses (up to 10) of the network devices that will be permitted access to
the unit when "Filter" is set to "On".
■ Setup procedure
1
Use the cursor keys (q/w) to select "MAC Address 1-5" or "MAC Address 6-10" and press
ENTER.
2
Use the cursor keys (q/w) to select an MAC address number and press ENTER.
3
Use the cursor keys (e/r) to move the edit position and the cursor keys (q/w) to select a
value.
4
To confirm the setting, press ENTER.
5
To save the changes, use the cursor keys to select "OK" and press ENTER.
6
To exit from the menu, press ON SCREEN.
132
En