Genelec 6010A Operating Manual page 7

SySTeM SPeCIFICATIONS
Lower cut-off frequency, –3 dB:
Upper cut-off frequency, –3 dB:
Free field frequency response of system:
Maximum short term sine wave acoustic output on axis
in half space, averaged from 100 Hz to 3 kHz:
Maximum long term RMS acoustic output in same
conditions with IEC weighted noise (limited by driver
unit protection circuit):
Maximum peak acoustic output per pair in half space
@ 1 m with music material:
Self generated noise level in free field @ 1 m on axis:
Harmonic distortion at 85 dB SPL @ 1 m on axis:
Frequency: 70...400 Hz
Drivers: Bass
Treble
Weight:
Dimensions: Height
(including Iso-Pod™ table stand)
Height
(without Iso-Pod™ table stand)
Width
Depth
< 73 Hz
> 21 kHz
74 Hz – 18 kHz (± 2.5 dB)
@ 1 m > 93 dB SPL
@ 0.5 m > 99 dB SPL
@ 1 m > 91 dB SPL
> 102 dB
< 5 dB (A-weighted)
< 3 %
> 400 Hz < 0.5 %
76 mm (3") cone
19 mm ( / ") metal dome
3
4
1.4 kg (3.1 lb)
195 mm (7 / ")
11
16
181 mm (7 / ")
1
8
121 mm (4 / ")
3
4
114 mm (4 1 / ")
2
CrOSSOver SeCTION
Signal input connector:
Input level for 90 dB SPL output at 1 m:
Level control range:
Crossover frequency, Bass/Treble:
Desktop Control operating range:
Bass Tilt control operating range in –2 dB steps:
The 'CAL' position is with all tone controls set to 'off'
and the input sensitivity control to maximum (fully
clockwise).
AMPLIFIer SeCTION
Bass amplifier output power with an 8 Ohm load: 12 W
Treble amplifier output power with an 8 Ohm load: 12 W
Long term output power is limited by driver unit
protection circuitry.
Amplifier system distortion at nominal output:
Mains voltage:
Voltage operating range:
Power consumption:
RCA female, unbalanced
10 kOhm, pin +, sleeve -
-6 dBu at level control max
-12 dB relative to maximum
output
3.0 kHz
0 to –4 dB @ 200 Hz
0 to –6 dB @ 100 Hz
THD + N < 0.08 %
100, 120, 220 or 230 V
according to region
±10 %
Idle 5 VA
Full output 35 VA