Contents 1 Important 8 Product information Safety Specifications 2 Your clock radio 9 Troubleshooting Introduction General What's in the box About Bluetooth device Overview of the clock radio 10 Notice 3 Get started Install battery Connect power Turn on 4 Set time and alarm Set time Set alarm timer 5 Listen to FM radio...
1 Important c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. Safety f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the Know these safety symbols manufacturer's instructions.
Page 5
o Apparatus shall not be exposed to dripping or splashing. p Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). q Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can • play audio from Bluetooth-enabled devices, or other external devices; • listen to FM radio;...
Overview of the clock radio a SCAN/ h AL1/AL2/- VOLUME + • Press to set sleep timer. • Set alarm. • Press and hold for two seconds to • Adjust volume. store radio stations automatically. SOURCE • Press and hold for two seconds to •...
3 Get started Connect power Caution Always follow the instructions in this chapter in • Risk of product damage! Make sure that the power sequence. voltage corresponds to the voltage printed on the back or underside of the clock radio. •...
4 Set time and Press HR or MIN to select an alarm source: FM radio or buzzer. alarm Press AL1 or AL2 again to confirm the alarm settings. Note • If the clock radio is idle for 10 seconds, it exits alarm Set time setting mode automatically.
5 Listen to FM Store FM radio stations radio automatically In FM tuner mode, press and hold SCAN for two seconds. » All available FM radio stations are stored automatically. Prepare FM antenna » The first stored radio station broadcasts. For better reception, fully extend and adjust the position of the pig-tail antenna.
(refer to the user manual of the device). • You can press to start, pause or When [Philips AJT5300] is displayed on resume play. your device, select it to start pairing and connection. If necessary, enter default password “0000”.
Control your phone call After Bluetooth connection, you can control your incoming phone call with this product. Button Function Press to answer an incoming call. During a call, press to end the current call. Press and hold for two seconds to reject an incoming call.
7 Other features Listen to an external device With this clock radio, you can also listen to an external audio device such as an MP3 player. Connect an audio input cable (not Charge your phone supplied) with a 3.5 mm connector on both ends to the AUDIO IN socket on the clock With this clock radio, you can charge your...
To deactivate the sleep timer: • Press repeatedly until [OFF] (off) appears. • If you press in standby mode, the clock radio will switch to FM tuner mode. Adjust volume While listening, press - VOLUME + to adjust volume. Adjust display brightness Press BRIGHTNESS repeatedly to select different brightness levels: •...
8 Product AC Power (Power Adapter) Brand name: PHILIPS; information Model: Y12FE-050-2000U; Input: 100-240V~, 50-60 Hz, 0.35 A; Note Output: • Product information is subject to change without prior notice. 2000 mA; Operation power consumption: 8.7 W Specifications Standby power consumption: <1 W...
About Bluetooth device device, check the following points before requesting service. If the problem remains The audio quality is poor after connection unsolved, go to the Philips Web page (www. with a Bluetooth-enabled device. philips.com/support). When you contact Philips, • The Bluetooth reception is poor. Move the...
These limits are designed to provide reasonable your local authorities or visit www.recycle. protection against harmful interference in a philips.com. residential installation. This equipment generates, Environmental information uses, and can radiate radio frequency energy All unnecessary packaging has been omitted.
Page 18
This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. AJT5300_37_UM_V3.0...