Install Pcle Add-In Cards - Synology SA3600 Hardware Installation Manual

To make sure SA3600 recognizes the new memory capacity:
1 Log in to DSM as admin or a user belonging to the administrators group.
2 Check Total Physical Memory
To remove the RAM Module:
1 Follow step 1 and 2 of the To install the RAM module section to shut down your SA3600, disconnect the
cables, and then remove the rear top cover.
2 Cut the cable tie before removing the memory module. (The pre-installed memory module is cable tied to
prevent loosening during delivery.)
Note: Avoid touching any components of the motherboard when you cut the cable tie.
3 Disengage the memory retaining clips by pushing them outward, and the module will pop out of the slot.
4 Follow step 4 of the To install the RAM module section to put back the top cover.

Install PCle Add-in Cards

SA3600 provides two PCIe slots for optional add-in card expansion, allowing network interface cards to be
installed.
To install the network interface cards:
1 Shut down your SA3600. Disconnect all cables connected to your SA3600 to prevent any possible damages.
2 Open the SA3600 by following step 2 of the To install the RAM module section.
3 Install the network interface card.
a Remove the screw that secures the expansion slot's cover.
b Lift the expansion slot's cover.
13 Chapter 2: Hardware Setup
in Control Panel > Info Center.