Sony LBT-V8900AV Operating Instructions Manual page 6

Step 1: Hooking up the system
(continued)
If your TV automatically changes the color
system according to the input signal:
The factory setting (AUTO) automatically
changes the color system of the video output
according to the color system of the current
VIDEO CD. If you turn off the system, the
color system will be set to NTSC
automatically when you turn on the system
again.
If the color system of your TV is NTSC:
Set SYSTEM SELECT to NTSC.
Picture recorded in the PAL color system will be
stretched vertically and will be displayed with the
upper and lower parts of the picture cut off.
If the color system of your TV is PAL:
Set SYSTEM SELECT to PAL.
Picture recorded in the NTSC color system will be
stretched horizontally and will be displayed with
the upper and lower parts of the screen masked in
black.
Note
Be sure to turn off the system before changing the
SYSTEM SELECT setting.
5
Set VOLTAGE SELECTOR to the
position of your local power line
voltage (except for Chinese model).
VOLTAGE SELECTOR
110-120V
6
Connect the power cord to a wall
outlet.
The demonstration appears in the
display.
If the plug on this unit does not fit your
wall outlet, detach the supplied adapter
from the plug (except for Chinese
model).
6
220-240V
7
Deactivate the demonstration mode
by pressing DISPLAY/DEMO while
the system is off.
To attach the center surround
speaker feet
Attach the four center speaker feet (supplied)
to the bottom corners of the center surround
speaker.
Inserting two size AA (R6)
batteries into the remote
Using the remote
You can use the shaded buttons shown below
to operate Sony TV.
TV/VIDEO
TV POWER
TV VOL +/–
TV CH +/–