Table of Contents
Advertisement
Programming CD tracks
(continued)
1
Place CDs and close the front cover.
2
Press FUNCTION repeatedly until
"CD" appears in the display.
3
Press PLAY MODE repeatedly until
"PROGRAM" appears in the
display.
4
Press DISC SKIP to select a CD.
5
Turn the jog dial until the desired
track appears in the display.
Disc number
DISC PROGRAM
6
Press PLAY MODE once.
The track is programmed. "STEP" and
the programmed playing order appear,
followed by the total playing time.
DISC PROGRAM
7
To program additional tracks,
repeat steps 4 through 6.
Skip step 4 to select tracks from the same
disc.
8
Press ·.
All the tracks play in the order you
selected.
40
Track number
DOLBY NR
OFF
Total playing time
The last programmed track
DOLBY NR
OFF
Total playing time
To cancel Program Play
Press PLAY MODE repeatedly until
"PROGRAM" or "SHUFFLE" disappears
from the display.
To
Check the program
Clear the last selected
track
Clear a specific track
Add a track to the
program
Clear the entire
program
Tips
• The program you created remains in the CD
player's memory even after it has been played.
Press · to play the same program again.
• If "--.--" appears instead of the total playing time
while programming, this means:
– you have programmed a track numbered over
20, or
– the total playing time has exceeded 100 minutes.
Press
CHECK on the remote
repeatedly. After the
last track, "CHECK
END" appears.
CLEAR on the remote
in stop mode.
CHECK on the remote
repeatedly until the
number of the track to
be cleared lights up,
then press CLEAR.
1 Press DISC SKIP to
select a CD.
2 Turn the jog dial to
select a track.
3 Press PLAY MODE.
p once in stop mode or
twice while playing.
Advertisement
Table of Contents
