Specifications - Makita SG1251 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Wheel diameter
Max. wheel thickness
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance
Directive,
Electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting tracks in concrete walls
or cutting in ferrous materials or concrete drainage
channels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model
Rated speed
Spindle thread
Overall length
Net weight
Safety class
with household
of the
on Waste Electric
Equipment
environmentally compatible
END202-8
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Vibration
The vibration
waste
determined according to EN60745:
European
Work mode : concrete cutting
and
Vibration emission (a
and its
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENE026-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENF002-2
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
SG1251
125 mm
2.1 mm
-1
10,000 min
M14
350 mm
4.5 kg
/II
A-weighted noise level
) : 97 dB (A)
pA
) : 108 dB (A)
WA
Wear ear protection
total value (tri-axial
2
) : 5.0 m/s
h
2
ENG905-1
determined
ENG900-1
vector sum)
ENG901-1