DeWalt DCD995 Instruction Manual page 14

To remove the battery pack from the tool, press the release button (I)
and fi rmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
FIG. 9
I
FUEL GAUGE BATTERY PACKS (FIG. 10)
Some D WALT battery packs include a fuel gauge which consists of
E
three green LED lights that indicate the level of charge remaining in the
battery pack.
To actuate the fuel gauge, press and hold the fuel gauge button (M). A
combination of the three green LED lights will illuminate designating the
level of charge left. When the level of charge in the battery is below the
usable limit, the fuel gauge will not illuminate and the battery will need
to be recharged.
FIG. 10
M
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please call
1-800-4-D
com.
Screwdriving (Fig. 3)
1. Select the desired speed/torque range using the gear shifter to
H
2. Turn the torque adjustment collar (E) to the desired position.
3. Insert the desired fastener accessory into the chuck as you would
4. Make some practice runs in scrap or on unseen areas of the
5. Always start with lower torque settings, then advance to higher
NOTE: When torque is achieved in screwdriving mode, the unit will
automatically shut off with a set of short pulses.
Drilling (Fig. 4)
NOTICE: If drilling thin material, use a wood "back-up" block to
prevent damage to the material.
1. Select the desired speed/torque range using the gear shifter to
12
WALT (1-800-433-9258) or visit our website www.dewalt.
E
match the speed and torque to the planned operation.
NOTE: Use the lowest torque setting required to seat the fastener
at the desired depth. The lower the number, the lower the torque
output.
any drill bit.
workpiece to determine the proper position of the torque
adjustment collar.
torque settings to avoid damage to the workpiece or fastener.
match the speed and torque to the planned operation. Turn the
collar (E) to the drill symbol.