Maintenance; Specifications - Makita XRM04B Instruction Manual

Charging with USB power supply port
(Fig. 9)
• The USB jack charging function can work in all modes
except AM mode. AM band is automatically changed to
FM band when charging starts.
• The maximum volume of the output power speaker will
decrease when your USB is charging.
• The USB socket can provide max 1A5V of electrical
current.
Important:
• Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
• The charger may not supply power to some USB
devices.
• When not using or after charging, remove the USB
cable and close the cover.
• Do not connect power source to USB port. Otherwise
there is risk of fire. The USB port is only intended for
charging lower voltage device. Always place the cover
onto the USB port when not charging the lower voltage
device.
• Do not insert a nail, wire, etc. into USB power supply
port. Otherwise a circuit short may cause smoke and
fire.
• Do not connect this USB socket with your PC USB
port, as it is highly possible that it may cause
breakdown of the units.

MAINTENANCE

CAUTION:
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.

Specifications:

Power Requirements
AC power adaptor
Battery
Frequency coverage
®
Bluetooth
®
Bluetooth QD ID
®
(The Bluetooth word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc.)
®
Bluetooth version
®
Bluetooth profiles
Transmission power
Transmission range
Supported codec
®
Compatible Bluetooth profile
DC12V/1,200 mA, center pin
positive
UM-3 (AA size) x 2 for back up
Cluster battery: 7.2 V - 10.8 V
Slide battery: 14.4 V - 18 V
FM 87.50 - 108 MHz
(0.1 MHz/step)
AM (MW) 520 - 1,710 kHz
(10 kHz/step)
58625
4.0
A2DP/SCMS-T
®
Bluetooth specification power
Class 2
Max. 10 m (30 ft) (varies
according to usage conditions)
SBC
A2DP
Circuit feature
Loudspeaker
Output Power
Input terminal
Antenna system
Dimension (W x H x D) in mm
Weight
3.5 inches 8 ohm x 2
7.2 V: 0.5 W x 2
10.8 V: 1.2 W x 2
14.4 V: 2.2 W x 2, 18 V: 3.5 W x 2
3.5 mm dia. (AUX IN1/AUX IN2)
FM: soft bended rod antenna
AM: bar antenna
282 x 294 x 163
(11-1/8" x 11-5/8" x 6-3/8")
4.3 kg (9.5 lbs) (without battery)
11