Related Manuals for Makita XRM04
Summary of Contents for Makita XRM04
- Page 1 Job Site Radio Instruction manual Radio de chantier Manuel d’instructions Radio de Trabajo Manual de instrucciones XRM04 IMPORTANT: Read Before Using. IMPORTANT : Lisez les instructions avant l’utilisation. IMPORTANTE: Leer antes de usar.
- Page 2 (19) 2 3 4 5 (20) (21) (22) (23) (24)
-
Page 5: Important Safety Instructions
If liquid contacts eyes, causing fires, personal injury and damage. It will also void additionally seek medical help. Liquid ejected from the the Makita warranty for the Makita tool and charger. battery may cause irritation or burns. Tips for maintaining maximum battery life SAVE THESE INSTRUCTIONS. -
Page 6: Lcd Display
18. Battery compartment (covering main battery pack and For United States: back up batteries) 19. Up Cautions to the user 20. Left The changes or modifications not expressly approved 21. Front by the party responsible for compliance could void the 22. - Page 7 The following table indicates the operating time on a single charge in Radio mode. AT SPEAKER OUTPUT = Battery Cartridge Voltage 50 mW + 50 mW Battery unit Hour (APPROX.) capacity 7.2 V 10.8 V 14.4 V 18 V Radio/AUX BT + USB 1.0 Ah BL7010...
- Page 8 Installing or removing Cluster battery Using the soft bended rod antenna cartridge (Fig. 6 & 7) (Fig. 9) • To insert the battery cartridge, align the tongue on the Straight up the soft bended rod antenna as shown in the battery cartridge with the grove in the housing and slip figure.
-
Page 9: Clock And Alarms
• FM/AM will flash approx. 10 seconds. Within this 1. Press the Power button as needed to select the period, only manual tuning is allowed. FM band and tune to the desired FM station as • If volume adjustment is desired while FM/AM is previously stated. -
Page 10: Radio Data System (Rds)
confirm the setting. Then rotate the Tuning control ONCE – the alarm will sound once knob to select the desired minute, and press the DAILY – the alarm will sound everyday Tuning control knob to confirm the setting. WEEKDAY – the alarm will sound only on weekdays 4. -
Page 11: Auxiliary Input Socket
Disabling/cancelling alarms 4. To turn off the loudness function, select OFF and press the Tuning control knob to confirm the To disable an active alarm, either press the Power button setting. , or press and hold the corresponding alarm button to cancel the alarm. -
Page 12: Maintenance
Note: onto the USB port when not charging the lower voltage ® a) The radio can pair with 8 Bluetooth devices at most. device. ® When you pair Bluetooth devices more than this • Do not insert a nail, wire, etc. into USB power supply number, pairing history will be overwritten from the port.