Simpson Megashot MS61049 Instruction Manual page 11

K. Quick Connect Nozzles OR 5n1 Multi-tip Nozzle (not shown)
L. Detergent Tank (if equipped): Feeds cleaning agents into the pump to mix
with the water. See How To Apply Chemicals/Cleaning Solvents instructions
in Operation section
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
ASSEMBLY INSTRUCTIONS (FIG. 2–4)
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the panels flat.
3. (Figure 2) Place handle (G) onto frame (H), depress the snap buttons, and slide
the handle assembly onto the frame until snap buttons snap into place.
OR
(Figure 2A) Slide the handle assembly (G) onto the frame (H) and secure with
saddle bolts and knobs.
NOTICE: Risk of personal injury. Avoid placing hands between handle and frame
when assembling to prevent pinching.
2
G
H
4. (if equipped) Remove the colored quick-connect nozzles (K) from the plastic
bag and insert them into correct grommet on the nozzle holder. Nozzles are
color coded to match colored nozzles on label.
5. Connect wand (E) to gun (D). Tighten securely.
6. Attach high pressure hose (C) to gun (D). Tighten se cure ly.
3
D
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered under warranty.
NOTE: The pump on this unit is maintenance free and requires no oil. If
there is a problem with the pump, contact our Customer Service Group on
www.simpsoncleaning.com as soon as possible.
2A
G
OR
H
4
E
11 - ENG
(if equipped)
2B
K
D
C