Start-Up, Heating & Programing - Star GRILL-MAX 30C Assembly, Installation And Operation Instructions

OPERATING PROCEDURES FOR ELECTRONIC GRILLS
START-UP
When initially turning on power to the electronic
controlled grill, it will be in the HOLD mode. The
displays will flash until the setpoint temperature
is reached. The grill will beep once when it is
up to temperature. Infinite controlled grills have
no notification when operating temperature is
reached.
HEATING
The size, content, and shape of the product and the
installation of any sanitary food shields or sneeze
guards will determine the proper heat setting. The
National Sanitation Foundation requires that all
perishable foods be kept at 140°F or above during
serving periods.
The product should be kept refrigerated until ready
to use. Heating times vary depending on the starting
temperature and the qualities of the product. For
best results, use a hot dog made for grilling.
Before cooking for the first time, wash the rollers
with mild soap and water using a soft cloth. When
the electronic controled grills are initially turned on,
the displays will flash the HOLD temperature until
the grill reaches that setpoint.
With the grill preheated to the hold temperature,
load with the desired product and press the HEAT
button. The grill will then go into the heat mode and
the displays will flash until the HEAT temperature
is reached. After the heating cycle, the grill will
beep four times and the food product will be at the
serving temperature.
NOTE: Based on the product being heated, some
experimentation is required to find the optimal HEAT
temperature and HEAT time to bring the product up
to temperature in an acceptable amount of time.
PROGRAMMING
The electronic controls provide programmable HEAT
and HOLD settings for a variety of food products
and installation conditions.
To program the electronic roller grill:
1. With the grill on, push and hold the
the side you wish to program together for three
seconds until the alarm beeps once and the display
blanks.
2. To set the heat temperature and/or heat time, push
the heat button. The last saved heat time will be
displayed and the HEAT LED will flash and HEAT
TIME indicator will be ON. Use the
buttons to adjust to the desired time, then press the
HEAT button again. The HEAT TIME LED indicator
will turn off and the HEAT TEMP LED indicator
will now be lit. When programming the HEAT
temperature is complete, push the HEAT button
one more time to exit the programming mode.
3. To set the hold temperature, repeat step 1 above
then push the HOLD button. The last saved hold
temperature will be displayed and HOLD LED will
be ON. Use the
desired temperature, then press the HOLD button
again to exit programming mode.
4. To turn the heat off to the front or rear section, press
and hold the
"OFF" will be displayed. To turn the section back
on, press the HEAT or HOLD button.
PAT. # 6,782,802 PAT. # 6,707,015 PAT. # 6,782,802 PAT. # 6,707,015
Electronic Control Board
6
6
and buttons to adjust to the
for that section for 3 seconds.


Seal-Max

DURATEC

MADE IN
PAT. # 6,393,971
U.S.A.
and on
and