Listen To Radio; Store Radio Stations Automatically; Tune To A Radio Station; Store Radio Stations Manually - Philips NTX400X User Manual

6 Listen to radio

Store radio stations
automatically
Note
•
You can program a maximum of 20 FM and 10 AM
radio stations.
•
time, the product prompts you to search and
store all the available radio stations.
1
Press SOURCE repeatedly to select FM or
AM tuner mode.
» [AUTO INSTALL-PRESS PLAY-STOP
CANCEL] (auto install-press play-stop
2
Press to start full scan.
» [AUTO] is displayed.
» The product stores all the available
radio stations automatically, and then
» The station list is memorized in the
product. When you enter the radio
mode next time, the station scan does
not take place.
Note
•
If you press , the product will not perform full scan,
and the same message will pop up when you enters FM
or AM mode next time.
• You can also press and hold PROG
for two seconds to activate automatic
programming.
» [AUTO]
» The product stores radio stations with
»
broadcast automatically.
EN
14

Tune to a radio station

Tip
•
Keep the product away from other electronic devices
to avoid radio interference.
•
For better reception, fully extend and adjust the
position of the antenna.
1
Press SOURCE repeatedly to select FM or
AM tuner.
2
Press and hold /
» [SEARCH] is displayed.
» The product tunes to a station with
strong signal automatically .
3
Repeat step 2 to tune to more stations.
• To tune to a station with weak signal,
press /
better reception.

Store radio stations manually

Note
•
You can program a maximum of 20 FM and 10 AM
radio stations.
1
Tune to a radio station.
2
Press PROG to activate the program
mode.
» A position number is displayed.
3
Press / to allocate a number to this
radio station, then press PROG
4
Repeat steps 1 to 3 to program other
stations.
Tip
•
To overwrite a pre-stored station, store another station
in its place.
for two seconds.