Power On/Off; Turning On The Power - Dukane 8962WU User Manual

Power on/off

Power on/off

Turning on the power

1.
Make sure that the power cord is
firmly and correctly connected to the
projector and the outlet.
2.
Make sure that the POWER indicator is
lighted in steady orange (112). Then
remove the lens cover.
3.
Press the STANDBY/ON button on the
projector or the remote control.
The projection lamp will light up and POWER indicator will begin blinking in
green. When the power is completely on, the indicator will stop blinking and
light in steady green (112).
To display the picture, select an input signal according to the section Selecting an
input signal (33).
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
(94) is executed. If you wish to change the settings, refer to the LANGUAGE
(76) and ALTITUDE (88) menu.
(1) LANGUAGE: Use the ▲/▼/◄/►buttons to
select the desired language and press the
ENTER button of the remote control or the
INPUT button of the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to select
NORMAL for altitude below 1600 m (5250 feet),
otherwise select HIGH and press the ENTER
button of the remote control or the INPUT button
of the projector to execute.
(continued on next page)
30
STANDBY/ON button
POWER indicator
INPUT
ASPECT PbyP
MAGNIFY FOCUS
ON
OFF
PAGE
UP GEOMETRY
DOWN INTERACTIVE
ESC
OSD MSG
MYBUTTON
1 2
MYBUTTON
INPUT 1 2
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
ON + + +
AUTO FREEZE
OFF - - -
PAGE
UP GEOMETRY PICTURE MUTE
DOWN INTERACTIVE NETWORK BLANK
ESC MENU
ZOOM VOLUME
+ + +
ENTER
OSD MSG RESET
- - -
PICTURE MUTE
NETWORK BLANK
MENU
ENTER
RESET