Pc/Av Mode; Displayport Ver; Hdmi Mode; Source Detection - Samsung U32R590CWU User Manual

PC/AV Mode

Set PC/AV Mode to AV. The picture size will be enlarged.
This option is useful when you view a movie.
• Set to PC when connected to a PC.
• Set to AV when connected to an AV device.
― Supplied for the wide models only such as 16:9 or 16:10.
― If the monitor (when set to HDMI, DisplayPort) is in power saving mode or is displaying the message
Signal Cable, press the icon to display the On Screen Display (OSD). You can select

DisplayPort Ver.

Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI, DisplayPort) is in power saving mode or is displaying the message
Signal Cable, press the icon to display the On Screen Display (OSD). You can select
― If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1
transmission speeds.

HDMI Mode

Select the HDMI mode to use.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode
limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
Check
device.
PC or AV.
― Set the
HDMI Mode
― Not available when
― If the monitor(when set to HDMI) is in power saving mode or is displaying the message
press the icon to display the On Screen Display(OSD). You can select

Source Detection

Check
1.1 or 1.2↑.
Select either Auto
― Not available when

Key Repeat Time

Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or
when a button is pressed.
to 1.4, some high resolutions may not be supported because of bandwidth
to 1.4 when there is no sound output from the DVD connected to our product.
PBP Mode is set to On.
or Manual as the method to recognize input signal.
PBP Mode is set to On.
2 sec can be selected. If No Repeat is selected, a command responds only once
Check Signal Cable,
1.4 or 2.0.
32