Ordering Accessories; Removing The Rechargeable Battery; Troubleshooting - Philips S528 Manual

7 Close the shaving head holders
(Fig. 13).
Storage
Always slide the protection cap
onto the shaving unit to protect the
shaving unit from dirt or damage
during traveling or storage (Fig. 21).
We advise you to let the appliance
dry before you store it.

Ordering accessories

To buy accessories or spare parts,
visit www.philips.com/parts-and-
accessories or go to your Philips
dealer. You can also contact the
Philips Consumer Care Center in
your country (see the international
warranty leaflet for contact details).
Available parts
The following accessories and
spare parts are available:
- SH30 Philips shaving heads
- HQ110 Cleaning spray
- A00390 supply unit
Note: Availability of the accessories
may differ by country.
Recycling
- Do not throw away the product
with the normal household
waste at the end of its life, but
hand it in at an official collection
point for recycling. By doing this,
you help to preserve the
environment.
- This product contains a built-in
rechargeable battery which shall
not be disposed of with normal
household waste. Please take
your product to an official
collection point or a Philips
service center to have a
professional remove the
rechargeable battery.
- Follow your country's rules for
the separate collection of
electrical and electronic
products and rechargeable
batteries. Correct disposal helps
prevent negative consequences
for the environment and human
health.
Removing the
rechargeable battery
Only remove the rechargeable
battery when you discard the
shaver. Before you remove the
battery, make sure that the
shaver is disconnected from the
mains and that the battery is
completely empty.
Take any necessary safety
precautions when you handle
tools to open the shaver.
Be careful, the battery strips are
sharp.
1 Disconnect the appliance from
the wall socket and let the
appliance run until the motor
stops.
2 Insert a screwdriver under the
edge of the upper front panel
and remove it (Fig. 22).
3 Undo the screws in the top part
of the shaver (Fig. 23).
4 Remove the cover in the top of
the handle (Fig. 24).
5 Insert a screwdriver under the
edge of the front panel to
remove the panel and on/off
button (Fig. 25).
6 Remove the small inner part
below the on/off button (Fig.
26).
7 Push the inner frame out of the
housing with the screwdriver
(Fig. 27).
8 Cut the wires with pliers and
remove the battery (Fig. 28).

Troubleshooting

This chapter summarizes the most
common problems you could
encounter with the appliance. If you
are unable to solve the problem
with the information below, visit
www.philips.com/support for a list
of frequently asked questions or
contact the Consumer Care Center
in your country.
Prob
lem
The
shaver
does
not
work as
well as
it used
to.
Possible
cause
The
shaving
heads
are
dam
aged or
worn.
Solution
Replace the
shaving
heads (see
'Replace
ment').