Thorough Cleaning; Replacing The Shaving Heads - Philips S528 Manual

and switch off the shaver before
you clean it.
Never use compressed air, scouring
pads, abrasive cleaning agents or
aggressive liquids such as petrol or
acetone to clean the appliance.
Be careful with hot water. Always
check if the water is not too hot, to
prevent burning your hands.
Never dry the shaving unit with a
towel or tissue, as this may
damage the shaving heads.
1 Rinse the shaving unit under a
warm tap.
Note: You can also clean the
shaving unit with the cleaning
brush supplied.
2 Turn the shaver up side down
and rinse the openings in the
bottom of the shaving head
holders. Switch on the shaver
briefly during rinsing (Fig. 10).
3 Open both shaving head holders
(Fig. 11).
4 Rinse the hair chambers and
shaving head holders under the
tap (Fig. 12).
5 Carefully shake off excess water
and let air dry completely.
6 Close the shaving head holders
(Fig. 13).

Thorough cleaning

The shaving unit consists of two
shaving heads. Clean one shaving
head at a time by following the
steps below.
1 Open the shaving head holder
(Fig. 11).
2 To unlock the retaining frame,
gently squeeze both sides of the
retaining frame and flip open
the frame (Fig. 14).
3 Remove the shaving head. Each
shaving head consists of a cutter
and a guard (Fig. 15).
Note: Do not clean more than
one cutter and guard at a time,
since they are all matching sets.
If you accidentally mix up the
cutters and guards, it may take
several weeks before optimal
shaving performance is restored.
4 Remove the cutter from the
shaving guard (Fig. 16).
5 Rinse both parts with water.
6 After cleaning, place the cutter
back into the guard with the
cutter legs pointing downwards
(Fig. 17).
7 Put the shaving head back into
the shaving head holder (Fig. 18).
Note: Make sure that the
shaving heads with the
projections fit exactly onto the
hooks of the shaving head
holder when placing them (Fig.
20). The shaving heads supplied
with this appliance either have
notches or projections. Both
shaving systems are the same.
8 Push the retaining frame back
onto the shaving head holder
until you hear a click (Fig. 19).
9 Close the shaving head holder
(Fig. 13).
Replacement

Replacing the shaving heads

For maximum shaving performance,
we advise you to replace the
shaving heads every two years.
Replace damaged shaving heads
immediately. Always replace the
shaving heads with original Philips
shaving heads (see 'Ordering
accessories').
1 Switch off the appliance.
2 Open the shaving unit by
opening both shaving head
holders (Fig. 11).
3 To unlock the retaining frames,
gently squeeze both sides of the
retaining frames and flip open
the shaving heads (Fig. 14).
4 Remove the shaving heads from
the shaving head holders (Fig.
15).
Throw away the used shaving
heads immediately to avoid
mixing them with the new
shaving heads.
5 Place the new shaving heads in
the shaving head holders.
Note: Make sure that the
shaving heads with the
projections fit exactly onto the
hooks of the shaving head
holder when placing them (Fig.
20). The shaving heads supplied
with this appliance either have
notches or projections. Both
shaving systems are the same.
6 Push the retaining frames back
onto the shaving head holder
until you hear a click (Fig. 19).