Before Starting The Equipment; Operation - EINHELL TP-AP 18/28 Li BL Operating Instructions Manual

5. Before starting the equipment

Warning!
Always remove the battery pack before making
adjustments to the equipment.
5.1 Changing the saw blade (Fig. 2)
Warning!
Switch off the reciprocating saw and pull out the
battery pack each time before doing any work on
the machine and changing the blade.
Turn the blade locking ring (6) on the blade holder
(4) as shown in Fig. 2 until the blade (7) lets itself
be slipped into the slot of the blade holder (4).
When you now let go of the ring (6) again, the ring
(6) should return to its starting position. If this fails
to happen, try turning the ring (6) by hand into its
starting position.
Now pull on the blade to check whether it is tightly
seated in the holder.
5.2 Adjusting the soleplate (Fig. 3)
Warning!
Pull out the battery pack.
To adjust the soleplate, press the soleplate
locking button (5) on the right-hand side (looking
from the bottom) in order to unlock the soleplate
(3). Set the required distance and press the
soleplate locking button (5) on the left-hand
side (looking from the bottom) in order to lock
the soleplate again. Check that the soleplate is
secure.
5.3 Fitting the battery (not included) (Fig. 4)
Push the battery into the battery mount provided.
When the battery is positioned as in Fig. 4, make
sure that the pushlock button latches in place! To
take out the battery, press the pushlock button
(10) and remove the battery.
Anl_TP_AP_18_28_Li_BL_USA_SPK7.indb 12 Anl_TP_AP_18_28_Li_BL_USA_SPK7.indb 12
EN

6. Operation

6.1 On/Off switch (Fig. 1/Item 1)
Switching on:
Press the locking button (2) and the On/Off switch
(1).
Infi nitely variable stroke speed control is possible
with the On/Off switch (1). The further you pull the
switch, the higher the stroke speed.
Switching off :
Release the locking button (2) and the ON/OFF
switch (1) at the same time
6.2 Using the reciprocating saw (Fig. 6)
Place the reciprocating saw, as shown in Fig. 6,
on the material you want to cut. Switch on the
reciprocating saw and push the reciprocating saw
against the material you want to cut. The cutting
speed must be adjusted to the material.
6.3 Swiveling the handle (Fig. 7 / Item 9)
The handle (8) can be swiveled 90° to the left
and right. To do so, pull the lock button (9) a little
backwards and swivel the handle (8) 90° to the
left or right. Let the lock button (9) engage again.
Caution! When the lock button (9) engages it
must make an audible click!
6.4 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.5 Battery capacity indicator (Fig. 5 / item
11)
Press the battery capacity indicator switch (12).
The battery capacity indicator (11) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
- 12 -
19.04.2022 12:39:40 19.04.2022 12:39:40