Page 1
• sophisticated • inspiring Model VBL2-18GD/18BZ Model VBL2-24BNK 800192 APPROVED FOR USE IN DAMP LOCATIONS allen + roth ® is a registered trademark ITEM #0970845 of LF, LLC. All Rights Reserved. 0970846 0970847 VANITY LIGHT MODEL #VBL2-24BNK VBL2-18BZ VBL2-18GD Français p.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY Fixture Mounting Plate (preassembled to fixture (A)) Mounting Plate Screw (preassembled to fixture (A)) Decorative Nut (preassembled to fixture (A)) (preassembled to fixture (A)) Side Plate HARDWARE CONTENTS (shown actual size) Wrench Plastic Wire Machine Anchor Fixture Qty.
Page 3
SAFETY INFORMATION • DO NOT connect the bare or green insulation fixture ground wire to the black (HOT) current-carrying wire or the white (NEUTRAL) house wire. Connection of the bare or green fixture ground wire to the black or white house wires may cause metal parts of the fixture to carry electrical currents. Under this condition anyone coming in contact with the fixture will receive electrical shock, which could cause serious injury or death.
Page 4
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 30 minutes Tools Required for Assembly (not included): Flathead Screwdriver, Phillips Screwdriver, Wire Strippers, Drill, 1/8 in.
Page 5
ASSEMBLY INSTRUCTIONS 3. Remove mounting plate (B) from fixture (A) by removing mounting plate screws (C) from the edges of the fixture (A). Save mounting plate screws (C) for later use. Determine the approximate location for the fixture (A). Place mounting plate (B) against the wall and mark the location of the hole using a pencil or a marker (not included).
Page 6
ASSEMBLY INSTRUCTIONS Prepare wires by stripping 3/4 in. of insulation from BLACK wire ends using wire strippers (not included). Connect WHITE wire from fixture (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire from fixture (A) to BLACK wire from outlet box using existing wire connector or wire connector (AA).
ASSEMBLY INSTRUCTIONS Attach fixture (A) to mounting plate (B) using the mounting plate screws (C) previously removed (Step 3, Page 5). NOTE: Before tightening mounting plate screws (C) completely, use level (not included) to check fixture (A) -- adjust if necessary. Restore power and test fixture (A).
CARE AND MAINTENANCE • Shut off main power supply. Wipe with soft cloth or use window cleaner. Do not use an abrasive cleaner. TROUBLESHOOTING WARNING: Before beginning work, shut off the power supply to avoid electrical shock. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION 1.