Toyotomi UTN-18AP User Manual page 78

● When selecting heating mode, the air conditioner operates under heat
mode. Heat indicator
for some models). Press
«FAN» button to adjust fan speed. Press
angle. (Cooling only unit will not receive heating mode signal. If setting heat
mode with remote controller, press ON/OFF button cannot start up the unit).
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay
1~5 minutes to blow air (actual delay time is depend on indoor ambient
temperature).
● Set temperature range from remote controller: 16~30℃ (61-86°F); Fan
speed: auto, low speed, low-medium speed, medium speed, medium-high
speed, high speed.
3 FAN button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, ,
Pressing this button can set fan speed circularly as: auto (AUTO),
medium, high.
Auto
Low speed
Note:
Note:
It's Low fan speed under Dry mode
● Under AUTO speed, air conditioner will select proper fan speed
X-FAN function Hold fan speed button for 2s in COOL or DRY mode, the icon "
automatically according to ex-factory setting.
displayed and the indoor fan will continue operation for a few minutes in order to dry
● It is Low fan speed under Dry mode.
the indoor unit even though you have turned off the unit. After energization, X-FAN
● X-FAN function Hold fan speed button for 2 seconds in COOL or DRY
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed
mode, the icon
after the unit is stopped to avoid mould.
for a few minutes in order to dry the indoor unit even though you have
Having set X-FAN function on: After turning off the unit by pressing ON/OFF
turned off the unit. After energization, X-FAN OFF is defaulted. X-FAN is
button indoor fan will continue running for a few minutes. at low speed. In this
not available in AUTO, FAN or HEAT mode.
period, Hold fan speed button for 2s to stop indoor fan directly.
This function indicates that moisture on evaporator of indoor unit will be
Having set X-FAN function off: After turning off the unit by pressing ON/OFF
blowed after the unit is stopped to avoid mould.
button, the complete unit will be off directly.
4 TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. icon is displayed on remote controller. Press this button again
to exit turbo function and
will run at super-high fan speed to cool or heat quickly so that the ambient
on indoor unit is ON (This indicator is not available
or
, then back to Auto.
to
Low-Medium speed
Medium-High speed
is displayed and the indoor fan will continue operation
icon will disappear. If start this function, the unit
button to adjust set temperature. Press
/ button to adjust fan blowing
High speed
78
low,
Medium speed
,
" is
GB