Table of Contents
Advertisement
Software Installation:
Your Mouse comes with Wheel Mouse software which allows you to assign special functions to the 3 programmable buttons on your Mouse.
To install the Wheel Mouse software, please follow the instructions listed below:
1. If you have installed any other mouse drivers/software for your computer, please uninstall them prior to the installation of the Wheel
Mouse software to avoid any software conflicts.
2. Place the Driver CD into the CD-ROM drive of your computer.
3. The Wheel Mouse setup screen will start automatically. To start the setup manually, click "Start", then "Run...", type
"D:\SETUP.EXE" into the dialog box (NOTE: "D:\" represents the drive letter assigned to the CD-ROM drive you are using. If D is
not the letter assigned to your CD-ROM drive, replace D with the appropriate drive letter.), then click "OK".
4. Follow the onscreen instructions to complete the installation. After the installation is complete restart your computer.
Wheel Mouse Configuration:
To configure your Mouse using the Wheel Mouse software, please follow the instructions below:
1. Make sure your Mouse is connected to your computer.
2. To open the Wheel Mouse Setting screen, right click the Wheel Mouse icon on the system tray of your desktop, and then select
"Setting".
7
Advertisement
Table of Contents
