OPTION menu
Remote control
See "Navigating through the MENU" on page 29.
See "Main menu and Sub-menu" on page 30.
INPUT GUIDE
When you change the input method, the guidance
appears in the upper right corner of the screen. The
following display methods are available. Press I H to
cycle through the options.
Options
OFF
Turn off the guidance.
Display the input method by text.
SIMPLE
The INPUT GUIDE will go out after
5 seconds without any operation.
Display the input method by graphic.
The INPUT GUIDE will go out after
10 seconds without any operation.
If you select any COMPUTER
DETAILED
terminal which has no signal, the
computer connection guidance will
be displayed. See "Computer
connection guidance" on page 48.
E
NGLISH - 36
Control panel
Function
STARTUP LOGO
You can switch the logo on/off that is displayed when
starting up the projector. Press I H to select the
required option.
ON
Active
OFF
Deactive
USER
Display the original text
Editing the original text
If you select USER, you can display the 2 lines of
original text up to 40 characters in 1 line instead of
the logo.
TEXT CHANGE
OK
1. Select USER and press ENTER.
2. Select the required line to enter or edit the original
text, and press ENTER.
3. Use F G I H to specify the location of the
required character and press ENTER.
The selected character will be displayed in the box.
Select DELETE to delete the last entered character
and press ENTER.
4. Repeat the step 3 until you finish the text to display
in a line.
5. Select OK and press ENTER to set the entered
text in a box.
Press G and edit the TEXT2 if you need to, and
repeat the step 3 - 5.
COMPUTER2 SELECT
You can switch the function of the COMPUTER2 IN/
1 OUT terminal.
INPUT
COMPUTER2 IN
OUTPUT
COMPUTER1 OUT
LAMP RUNTIME
You can check how long the lamp has been used.
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See "Replacing the Lamp unit" on
page 43.
• When the lamp unit is replaced with the new one
(ET-LAF100), the setting will be reset to "0".
DELETE
CANCEL