Panasonic PT-RZ770 Operating Instructions Manual page 62

Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[STANDBY MODE].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When the [PROJECTOR
SETUP] menu → [INITIALIZE] → [ALL USER DATA] is executed, the [STANDBY MODE] setting before executing is displayed.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each item from the [DISPLAY OPTION] menu →
[SCREEN SETTING].
1) Press qw to switch the setting.
f The setting will change each time you press the button.
62 - ENGLISH
INITIAL SETTING
STANDBY MODE NORMAL
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
CHANGE
SET
ENTER
INITIAL SETTING
SCREEN FORMAT 16:10
SCREEN POSITION
Set as necessary for the screen in use.
MENU SELECT CHANGE
SET
ENTER
4/7
5/7