Side-Mounted Connection Terminals - Panasonic PT-D5500EL Operating Instructions Manual

Side-mounted
connection terminals
VIDEO IN terminal (page 19)
An input terminal for video signals. (BNC)
S-VIDEO IN terminal (page 19)
An input terminal for S-video signals
(MIN4-pin DIN).
This terminal complies with S1 signals and
automatically toggles between 16:9 and 4:3
according to the size of input signals.
RGB (YP P )1 input terminal (pages 19, 20)
B R
A terminal to input RGB or YP
RGB (YP P )2 input terminal (page 20)
B R
A terminal to input RGB or YP
15-pin female).
DVI-D IN terminal (page 20)
DVI-D signals are applied to this terminal. (24-pin
DVI connector)
LAN terminal (page 37)
This terminal is used to control the projector from
the PC. (10Base-T/100Base-TX compliant)
R/P G/Y B/P
R B
S-VIDEO IN
VIDEO IN RGB 1 IN
REMOTE 1 REMOTE 2 IN
IN OUT
P signals (BNC).
B R
P signals (D-SUB
B R
SYNC/HD VD
RGB 2 IN DVI-D IN
IN SERIAL OUT
REMOTE1 lN/OUT terminal (page 16)
When two or more main units are used in the
system, they can be connected and controlled with
a wired remote control cable (M3 jack).
REMOTE2 IN terminal
The user can remotely control the main unit by
using an external control circuit to this terminal
(D-SUB 9-pin female).
SERIAL IN terminal (pages 20, 38)
Use the RS232C serial terminal as an alternative
interface for controlling the projector from your PC
(D-SUB 9-pin female).
SERIAL OUT terminal (page 20, 38)
The signal applied to the serial input port appears
at this terminal (D-SUB 9-pin male).
LAN
13