Table of Contents
Advertisement
Changing programme default settings
en
Starching
The laundry should not be
Note:
treated with fabric softener.
Liquid starch can be used in all wash
programmes. Pour starch into the
dispenser M according to
manufacturer's specifications
(if required, clean beforehand).
Dyeing/Bleaching
Dye in household quantities only. Salt
may attack stainless steel! Observe
specifications of the dye manufacturer!
Do not bleach laundry in the washer
dryer!
Soaking
Pour soaking agent/detergent into
1.
dispenser II according
to the manufacturer's instructions.
Set the programme selector to
2.
i Cottons 60°C and select A
Start/Reload
After approximately 10 minutes
3.
select A Start/Reload to pause the
programme.
After the required soaking time,
4.
reselect A Start/Reload if the
programme is to be continued or
change the programme.
Load laundry of the same colour.
Note:
No additional detergent is required,
the soaking solution is used for
washing.
36
0
Changing programme
default settings
Y ou can change the default settings for
C h a n g i n g p r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depend on the progress of the
programme.
°C Temp.
(: The indicated washing
temperature can be changed. The
maximum selectable washing
temperature varies depending on the
selected programme.
Overview of programmes ~ Page 32
0 rpm
0: The spin speed can be changed
before and during the programme (in
rpm, revolutions per minute) depending
on the progress of the programme.
Setting - - - - (Rinse stop = without final
drain/spin cycle), laundry remains in the
water after the last rinse cycle.
Setting 0 (Without any spin cycle), drain
the rinsing water only, no spin cycle.
The maximum spin speed depends on
the programme and model.
Overview of programmes~ Page 32
ñ Finished in
8:Define the Finish in time (end
of programme).
The respective programme
Note:
duration is displayed by selecting
the programme. The programme
duration is automatically adjusted while
the programme is running if the
programme duration needs to be
changed, e.g. due to changes in the
programme default settings.
Advertisement
Table of Contents
