Gateway NV55S02U Quick Start Manual page 25

Heat Build-up and Portable Computers
The AC adapter and the underside of the computer can become hot after prolonged use.
Sustained physical contact with either should be avoided.
C
HASSIS COVER REMOVAL AND REPLACEMENT
Before removing the chassis cover to service or modify the equipment, you must
disconnect all power and modem cords, and remove or disable the battery.
Caution: Some components inside the computer can become hot after
prolonged use.
You then must close the chassis before you plug in and switch on the equipment.
L C S
ASER OMPLIANCE
The optical devices are tested and certified to be compliant with International
Electrotechnical Commission IEC60825-1 and European EN60825-1 standards for Class
1 laser products.
Class 1 laser products are not considered hazardous. The optical devices are designed
such that there is never human access to laser radiation above a Class 1 level during
normal operation or prescribed maintenance conditions.
The optical devices installed in your computer are designed for use solely as components of
such electronic product and therefore do not comply with the appropriate requirements of
Code of Federal Regulation Sec. 1040.10 and Sec. 1040.11 for COMPLETE laser products.
Because exposure to laser radiation is extremely hazardous, under no circumstances
should the user attempt to disassemble the laser device.
P
ACKAGING
The packaging of this product is compliant with the European Environmental Directive 94/
62/EC from December 20 th 1994 and its equivalent in the French Legislation by the
Decree 98-638 from july 20 th 1998.
C R
OMPLIANT WITH USSIAN REGULATORY CERTIFICATION
TATEMENT
Regulatory information - 25