Haier QDHR35 Owner’s Manual And Installation Instruction page 8

USING THE DEHUMIDIFIER
There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed, the unit will shut
off. Empty and replace the bucket.
IMPORTANT: Do not use the hose if using the bucket to collect
water. When the hose is connected, water will flow through it
onto the floor instead of into the bucket.
NOTES:
• Do not remove the bucket while the dehumidifier is operating
or if it has just stopped operating. This might cause some
water to drip from the drain pan.
• The bucket must be in place and securely seated for the
dehumidifier to operate.
Water Level
The dehumidifier will turn off automatically when the bucket
is full, or when the bucket is removed or not replaced in the
proper position.
DO NOT remove the foam piece in the bucket assembly.
If removed the Dehumidifier will not work properly.
Use a hose. Water can be automatically emptied into a floor
drain by attaching a garden water hose (not included).
1. Remove the bucket from the front of the unit.
2. Open the drain cover on the side of the unit.
3. Thread a garden hose (not supplied) onto the nozzle, cut to
length, and lead it to the floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely seated for the
dehumidifier to operate.
The bucket must be replaced in the proper position for the
dehumidifier to work. The empty indicator will blink and the
dehumidifier will not run if the bucket is not in the proper
position.
49-5000430 Rev. 2